EZ Pull clutch lever for Brembo Black

The EZPull two-finger clutch lever makes riding easy when the going gets tough.
An optimized deflection saves you up to 30% of the force* required to pull your clutch.

Less power - more control

Unlike fewer clutch springs or tinkering with washers, the EZPull works where the power is created: right on your fingers.

Finally couple with one or two fingers. For hours.

• Produced in Germany.
• Each piece individually CNC-milled from 6082 aluminum (AlSi1MgMn)
• Lever axle mounted with sliding bush.

*may vary by vehicle.

Installation and adjustment:
Please make sure to warm up the motorcycle properly before assembly and adjustment.
When the engine is cold, the clutch does not disengage properly and a correct setting cannot be achieved.

The Allen head grub screw on the joint adjusts the pressure point on the pin of the clutch pump.
If the clutch does not disengage sufficiently, turn the screw further in... then turn it out again until it is still separated well.
Then it is best to put some Loctite on the adjusting screw.

Please do not try to reduce the distance between the lever and the handlebars with the screw. Then the clutch will not separate properly.