Motul 300V² 10W50 4T 1 litre

MOTUL 300V2 Factory Line 10W50 is a high-performance, smooth-running engine oil based on E technology, specially developed for racing motorcycles with 4-stroke engines that are designed for operation with a high warm viscosity. Both for use in street racing in the supersport, superbike, high-speed and mountain race classes, etc. and in the off-road area, such as MX, enduro, etc. Ideally suited for demanding motorcycle and quad engines in the street and off-road area

E Technology:

• MOTUL has been developing high-performance motor oils based on synthetic esters for several decades. The special selection of synthetic esters and the combination with an innovative additive package form an exceptional synergy. E is the latest technological development and enables maximum power output from the engine without compromising on reliability and wear. Very high pressure absorption capacity guarantees maximum lubricating security even in extreme temperature ranges. For modern engine technology with wet clutch and gear lubrication in the same oil bath. No clutch sticking and slipping.
• Fastest oiling right from the start phase reduces critical cold-start wear and guarantees a long service life for the engine.

Advantages in off-road use
Increased Torque:

• Low oil film traction at low speed. Torque improvement greater than 1% over a reference SAE 15W-60 viscosity grade oil on a Honda 450 CRF bench engine. Motul 300V² 4T Line Factory 10W-50 enables very fast torque build-up, better acceleration and handling.

Increased clutch grip:

• Optimized clutch behavior. The JASO T903 test is part of the JASO MA release and evaluates the friction performance of the clutch in connection with the engine oil over a very wide speed range. In the test, Motul 300V² 4T Factory Line 10W-50 showed a friction coefficient improvement of 2.3% compared to a comparable product from the market with the viscosity grade SAE 10W-50. Improved engine characteristics and traction control in tough off-road driving conditions.

Increased transmission reliability:

• Through maximum oil film stability. The FZG (Research Center for Gears and Transmissions) test assesses the lubrication and anti-wear properties of a gear set under high loads. E Technology combined with the additive package improves shear strength, wear protection and engine and transmission life. After an extremely long period of use of 300 hours and a speed of 3000 rpm, the gear surfaces showed only a very small pitting of 0.26%.

Recommendations and notes:
Change interval according to the specifications of the vehicle manufacturer/tuner or adjusted depending on the operating conditions. Before use, be sure to observe the service documents and recommendations of the manufacturer/tuner! Mixing with other synthetic or mineral lubricants is possible, but not recommended for optimal performance.

Specifications/Standards:
STANDARDS: Exceeds JASO & API requirements
JASO T903 Annex A (JASO MA friction coefficient requirements)